![]() The problem is that we have about 2000 - 3000 drawing made with autocad, and some don't have integer ratio related to standard sheet sizes (A4, A3. I tested the Steve Edmonds work around, but it doesn't work. If you use the option "Defined by selection window", please note that if width/length ratio of the paper in the printer is different from the width/length ratio of your drawing, the system prefers the size of the paper and needs to adjust the printed area.įor example, if the ratio of the paper is 3:4 and the ratio of your drawing is 1:5 (of course, these are extreme values just to demostrate differences), then it is obvious that after adjusting the printed format, you may see unselected objects on the printed paper or so.Īgain, before starting, select the right format and use the BOR command to have it displayed. Then, you can print without any problems. But it can be set just as you need (see Tools > Change Drawing Format). (By default it is set to A3 for mm and B 17x11 for inches. Before starting, select the right format and use the BOR command to have it displayed. The above is also suggested for every new 2D drawing you create in VariCAD. (Use the BOR command.) Then you can just choose print and it works. The recommended way is to choose the right drawing format and make sure everything fits inside the sheet border. Does VariCAD take its printer scaling from screen pixel position or resolution, is there a setting for this. I have noticed that the higher the resolution of the screen, the worse is the problem. ![]() I even tried before installing any printers in case it was printer driver related, but no difference. ![]() My computer prints much more than the selection box. The other computer prints a little more than the selection box. I recently upgraded both computers to SUSE 11.0 and VariCAD 2008-3.00. Other license computer has generally printed properly. What is interesting is that we have 2 licenses. To print I need to select a smaller area inside the drawing so that the complete drawing fits properly in the page. If I use the selection box to select just the drawing items or use "Only displayed objects" button the printed area is much bigger than the drawing. Since 2005 with every version of VariCAD and on SUSE 9.3 and now SUSE 11.0. I have always had a problem with the scaling of print outs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |